大家都搜：
燃尽温度
1、low temperature───低温，低温度；[物]低温
2、cpu temperature───cpu温度
3、temperature outside───室外温度
4、critical temperature───[物][电子]临界温度；n.临界温度
5、temperature rise───[电]温升；温度上升；温度上升，温升，升温
6、annealing temperature───[机]退火温度；退火点；退火点，退火温度
7、constant temperature───[热]恒温；定温；等温；等温，恒温
8、fluctuating temperature───波动温度；脉动温度；脉动温度，波动温度
9、temperature───n.温度；体温；气温；发烧
1、Influence of the Green Density and Binder Burnout Temperature on the Densification of Glass Bead───生坯密度和排蜡温度对玻璃绝缘子致密化影响
2、Combustion parameters such as ignition temperature, peak temperature of maximum weight loss rate, burnout temperature, maximum rate of combustion, and combustibility index were analyzed.───了燃烧特征参数如着火温度、燃烧速率最大时的温度、燃尽温度和最大燃烧速率以及燃烧特性指数。
3、To insure more densification but deformation of glass beads, the green density should be increased, and the burnout temperature of binder should be below the toplimit of transformation temperature.───为保证绝缘子获得较高致密度而不变形，应尽量提高生坯密度，同时排蜡温度应低于该种玻璃的转变温度上限。
4、rise of heating rate, the maximum release rate of volatile and combustion rate of char, the burnout temperature and the combustible parameter increased, but the ignition temperature…───的挥发分最大释放速率、固定炭最大燃烧速率、燃尽温度均呈增加趋势，它们的燃烧特性均随升温速率的升高而变好。
1、With the rise of heating rate, the maximum release rate of volatile and combustion rate of char, the burnout temperature and the combustible parameter increased, but the ignition temperature...
2、Combustion parameters such as ignition temperature, peak temperature of maximum weight loss rate, burnout temperature, maximum rate of combustion, and combustibility index were analyzed.
3、To insure more densification but deformation of glass beads, the green density should be increased, and the burnout temperature of binder should be below the toplimit of transformation temperature.