大家都搜：
abbr.主配线架，总配线架 (Main Distribution Frame)
1、screws mdf───螺钉mdf
2、thicknesses of mdf───中密度纤维板厚度
3、empires at war mdf───战争中的帝国mdf
4、sawing mdf───锯切中密度纤维板
1、Technical advantages: First, the only ash can be used with the MDF board (MDF), heaven and earth to build V-shaped grooves of the device.───开槽下角料为一根完整的技术优势：一、国内唯一可以采用灰纸板与密度板（中纤板）进行天地盖V形开槽的设备。
2、If the size selection cannot be justified, will result in an increase of MDF waste, the effective use of an area of paper reduction.───如果开本选用不合理，将使边料增加，纸张的有效利用面积减少。
3、They represent the basic version made of MDF with a natural ash-wood veneer.───这些盒子的基本款由中密度纤维板配岑木木皮制作而成。
4、Unsaturated polyesters are used for particleboard and MDF fillers and low-cost, low-cure-speed topcoats .───不饱和聚酯用于刨花板、MDF的填料，及低价、低固化速度的面层。
5、Hardboard is being replaced by MDF.───纤维板出篮，取而代之的是中密度纤维板。
6、The influence of changing the milled groove depth on testing results of the surface bonding strength of MDF was analysed through experiment.───通过试验分析比较铣槽深度的改变对中密度纤维板表面结合强度测试结果的影响。
7、Because of this unpredictable behavior, we recommended that you do not use this option for. Mdb or. Mdf files.───由于此行为不可预测，所以建议不要对.mdb或.mdf文件使用此选项。
8、advertising a product or tweeting affiliate links, MDF tries to get its users more followers.───MDF不对产品做广告或是在Twitter上发布分销链接，MDF只是试图帮助用户获得更多的关注者。
1、According to the contrast of relative creep deformation, MDF compounded with Breakingfruit Chinkapin and PVC had a good anticroop property.
2、Sawblade for cutting exotic and abrasive woods, chipboard, MDF panels up to 50 mm with a good finish. Use on table saws.
3、The middle density fibreboard(MDF) wastewater , which contains a great deal of tannin and xylogen mainly, usually can not be degraded by common physicochemical methods.
4、Good for: Multilayer board, Plywood, MDF, Foam.
5、Good for: MDF, Multilayer board, Plywood.
6、To assure quality, we use A-one MDF, customized PVC skin, wood paint . They are born with superb quality, fashionable design and fine workmanship.
7、Based on the curve of pressure-thickness of MDF mat, a comparison of some designs for hydraulic system of MDF multiple-opening hot-press has been made, and new designs are presented.
8、Hardboard is being replaced by MDF.
9、Boring and sizing paper laminated chipboard and MDF panels.