大家都搜：
溶解温度
溶液温度
1、low temperature───低温，低温度；[物]低温
2、temperature rise───[电]温升；温度上升；温度上升，温升，升温
3、temperature outside───室外温度
4、fluctuating temperature───波动温度；脉动温度；脉动温度，波动温度
5、temperature───n.温度；体温；气温；发烧
6、critical temperature───[物][电子]临界温度；n.临界温度
7、constant temperature───[热]恒温；定温；等温；等温，恒温
8、solution───n.解决方案；溶液；溶解；解答
9、annealing temperature───[机]退火温度；退火点；退火点，退火温度
1、The precipitation is very symmetrical and the size of it diminishes with the increase of solution temperature.───当固溶温度较高时，可观察到析出相非常均匀且尺寸较小。
2、With the rise of solution temperature, the thickness of recrystallized layer increase.───再结晶层厚度随固溶温度的升高而增大；
3、Take advantage of regulation fountain solution temperature way to control the aptitude-ink balance.───诳骗调控润版液温度的方法来把持火不朱不均具有独到的成果。
4、and it's solution temperature in alloy IN783 were investigated.───研究IN783合金显微组织及析出相，测定偏析相的初熔点温度。
5、The result showed that 3 exhibited clear thermosensitivity, and its lower critical solution temperature was 28.───研究结果表明，3呈现较好的温敏性，低临界溶液温度为28。
6、The cold work hardening is affected by both the recovery and recrystallization after cold work and by the solid solution temperature.───合金冷作硬化效果与合金的回复和再结晶程度及固溶处理温度有关。
7、effects of solution concentration, solution temperature and film Renault number on absorption performance were studied.───分析了溶液温度、浓度、降膜雷诺数对吸收效率和传质系数的影响。
8、The faster the scan rate or the lower the solution temperature, the less the R(subscript a) of same material.───扫描速度越快，溶液温度越低，同一材料的R（下标a）值越小。
1、Equilibrium sorption capacity increases with increasing initial lead concentration, solution temperature, solution pH and sorbent dose.
2、The fiber showed circular section, homogeneous structure without sheath and core, splendid mechanical properties and wide water solution temperature range.
3、With the rise of solution temperature, the thickness of recrystallized layer increase.
4、Chitin xanthate, cellulose xanthate and their blend solution belong to non-Newtonian fluid, where non-Newtonian Index increases and structure viscosity decreases with increasing solution temperature.
5、The segregative phases and it's solution temperature in alloy IN783 were investigated.
6、Methanol is suitable solvent for producing tetrabromobisphenol A, the factor of affecting product quality has: Solution temperature and acidity and fee ding speed of bromine.
7、The effect of solid solution temperature on the structure properties of LY 11 aluminium alloy is studied.
8、A new method for preparation of polysulfone hollow fiber ultrafiltration membranes using the lower critical solution temperature (LCST) systems has been developed.
9、The effects of different component of base solution, temperature, the height of Hg, Ei, the scan rate, the immobility time, the stabilization time were tested Study the reaction mechanism.