大家都搜：
点线法
1、point───vt.指向；弄尖；加标点于；n.(Point)人名；(法)普安；vi.表明；指向；n.要点；得分；标点；[机]尖端
2、standard method───标准方法；标准措施；标准措施，标准方法
3、gasometric method───气体容量法，气体定量分析法
4、method───n.方法；条理；类函数
5、averaging method───[数]求平均值法；均值法；平均法，均值法
6、evaluation method───评价法；[医]求值法
7、teaching method───教学方法；教学方式
8、stiffness method───[力]刚度法；劲度法
9、setter method───塞特法
1、Objective To explore the effect of the Point to point method of quality control in nursing quality management.───前言：目的探讨“点对点”质量管理的方法对护理质量管理的作用。
2、Scientist Shen Kuo in the Song Dynasty in its "Meng Xi Bi Tan" in the records produced by the needle point method.───宋代科学家沈括在其《梦溪笔谈》中记载了制作指向用的磁针的方法。
3、Trust region interior point method can settle the problem of adjusting step sizes on successive linear programming well.───信赖域内点法可以很好地解决逐线性规划方法中的步长调整问题。
4、There are correction methods, namely far aiming point method and correct target method.───校正方法有两种，即远方瞄准点法和校正靶法。
5、Using the result of skew-symmetric problem in interior point method theory, new proof of the dual theorems is obtained.───将原问题与对偶问题嵌入到一个斜对称问题之中，利用内点方法理论中斜对称问题的结果，给出了对偶定理的新证明。
6、The results reveal that the regression is by far better than the two-point. method.───其结果表明回归分析法远好于二点法。
7、For the voltage controlled system model, pole point method is taken to design the PID controller, and good result is achieved.───对于电压控制对象模型，采用极点配置的方法设计PIDKongZhiQi，均取得了较为满意的控制效果。
8、Use typical fix point method to survey system of farmer court economy, undertake to its economic benefits is analysed can drifting mixing.───采用典型定点法调查农户庭院经济XiTong，并对其进行能流和经济效益分析。
9、The conclusion that sequential two-point method is the best fit method for straightness measurement was arrived at the end of this paper.───最后由此得出两点法与三点法相结合的组合方法是最适用于超精密直线度测量的误差分离方法的结论。
1、This paper uses virtual neutral point method to measure the zero crossing, then the soft deal zero crossing to get the six key position to commutate.
2、Using difference method and collocation point method, this paper studies the bending problem for rectangular thin plates with mixed boundary.
3、The boundary point method has been applied to solve the problem of dam foundation seepage, and its results are compared with the results from finite element method and fissure network method.
4、In this paper, the boundary point method(BPM) is applied to the study of the non unique solution at characteristic frequency for exterior acoustic radiation caused by vibrating body.
5、In this paper, the boundary point method (BPM) is applied to calculating the exterior acoustic radiation problem caused by the vibrating body.
6、Generally, base point method is used when we analyze the acceleration of a paint in the plane figure, we seldom use the instantaneous center method.
7、The results showed that using the boundary point method to calculate seepage problem has the advantage of easy calculation program, high calculation accuracy, and easy to master and extend.
8、The paper uses primal - dual interior point method to acquire the optimal solution.
9、After the analysis on the error existed in the calculation to unresisting flow rate of gas well in Changqing oilfield, the original one point method is corrected.