大家都搜：
n.张应力
1、tensile strength───[力]抗张强度；n.抗张强度
2、tensile───adj.[力]拉力的；可伸长的；可拉长的
3、tensile modulus───[力]拉伸模量；定伸强度；抗张模量
4、tensile toughness───断裂韧性
5、tensile structures───抗拉结构；拉膜结构
6、alternating stress mean stress───交变应力平均应力
7、tensile load───拉伸负荷，拉伸载荷
8、tensile test───[力]拉力试验；抗拉试验；拉力试验，拉伸试验，抗拉试验
9、stress───n.压力；强调；紧张；重要性；重读；vt.强调；使紧张；加压力于；用重音读；n.(Stress)人名；(意)斯特雷斯
1、In terms of the zone under tensile stress, the existence of ventral moment is beneficial, but negative to the zone under compressive stress.───对于承受压应力的那个区而言，腹杆弯矩的存在是不利的。
2、zone of tensile stress moved to the frenal notch from the pre palate.───拉应力中区由基托前腭部移动到唇系带切迹区。
3、SEALS. ELASTOMER BASE MASTICS USED FOR SEALING. DETERMINATION OF ADHESIVNESS-COHESION. CHARACTERISTICS UNDER TENSILE STRESS.───缝隙.密封缝隙用弹性胶泥，拉力作用下附着粘度性能测定
4、We would like to know the tensile stress in the wall.───我们很想知道壁内的拉应力。
5、After the crack initiating, it propagates along the vertical direction of the tensile stress axial line.───裂纹萌生后主要沿着与拉应力轴垂直的方向扩展。
6、The tensile stress of trapezoid and rectangle were along the top and bottom edge of the linear distribution.───长方形、梯形拉应力均沿顶、底边线性分布。
7、In the structural design of the windows, it should be noted that the surfaces in high tensile stress should not contact with moisture.───在舷窗结构设计时还应避免使处于张应力的表面与水分接触。
8、Since the cope is usually made by flamed cutting, a high residual tensile stress exists along the burned edge.───由于修割工作通常用火焰烧割，沿着烧切边缘就存着较高的残余拉应力。
9、Plastic deformation concentrates at the ferrite area under the tensile stress es.───在拉应力作用下，塑性变形集中在铁素体区。
1、The new formula for computing the allowable tensile stress given in the new specifications is not reasonable.
2、We would like to know the tensile stress in the wall.
3、Research results: Under the same load condition, the tensile stress of ballastless track slabs without close connected is bigger than that of slabs with close linkage structure.
4、But under the control of NE-SW tensile stress field of Early Cretaceous, in the eastern part of Ergun Block sag belt was formed and the basement tectonics is NE-NNE direction.
5、The specimen deforms under a tensile stress applied parallel to the fibres.
6、Figure 4 shows a plot of tensile stress versus distance from the weld for 6061, revealing curves for both T4 and T6 material in both the as-welded (AW) and post-weld-aged (PWA) conditions.
7、Tensile stress and compressive stress have different effects on the magnetic domain structure.
8、Tensile strength corresponds to the maximum tensile stress that may be sustained by a specimen.
9、These outside conditions include environmental temperature, voltage, tensile stress, and bending load.