injection speed（意思翻译）

[机]压射速度

injection speed（相似词语短语）

1、dependency injection───依赖注入

2、injection mold───[塑料]注塑模具

3、amnios injection───羊膜注射

4、cash injection───资金注入

5、corticosteroid injection───PiZhiLeiGuChun注射

6、direct injection───直接射油，直接注入；[动力]直接PenShe；直接注入；直接射出法

7、alegar injection───阿莱加注射液

8、administering injection───注射给药

9、speed───v.快速运动；加速；促进；（使）繁荣；超速驾驶；（非正式）用XingFenJi成瘾；n. (Speed)斯皮德（人名）；n.速度，速率；进度；迅速；繁荣；感光度；排挡；（非正式）安非他明

injection speed（双语使用场景）

1、Injection Speed affects the viscosity of the molten material.───注射速度影响熔体粘度

2、Injection speed may be too slow causing freezing before mold is filled.───即计量太小）注射速度太小导致充填结束之前树脂凝固。

3、The injection speed can reach more than 5M/S and it can produce thin wall die castings stably.───压射速度达5M/S以上， 能稳定生产薄壁压铸件；

4、Excessively high injection speed can cause high surface orientation and increase susceptibility to stress cracking.───过高的注塑速度会引起较高的表面方向性及增加应力破裂的敏感性。

5、Rate of pressure drop (controlled primarily by injection speed) ?───压降的减少（主要控制由注射速度）

6、Adaptive control in tracking the constant injection speed the error decrease slowly, the track occurs and dithering when the speed changes.───自适应控制在跟踪恒定注射速度时误差减小较慢，在速度发生突变时的跟踪容易发生超调和抖动。

7、As a rule, the injection speed should be the faster the better.───作为原则，注射速度应越快越好。

8、It also showed the depressor effect of Shuanghuanglian Injection was affected by injection speed and concentration.───同时表明注射速度和浓度直接影响双黄连注射剂的降压作用强度。

9、Multi step adjustment of injection speed or pressure.───多级压力、多级速度射胶调整。

injection speed（英语使用场景）

1、Too fast injection speed: burns flash , air bubble inside or melt jet.

2、Under certain gas-liquid ratio and injection speed, the jel foam breakthrough pressure in porous media decrease with the permeability increasing.

3、The influence of nozzle port opening width parameter on injection speed under different injection pressures was investigated in this paper.

4、The residual resistance factors and the depleted layer thickness of Xanthan solution decrease with injection speed increase, but recovery does not vary much.

5、By use of orthogonal test design, how the injection speed, pouring temperature and mold temperature effects the casting shrinkage porosity forming is studied.

6、Excessively high injection speed can cause high surface orientation and increase susceptibility to stress cracking.

injection speed（相关推荐）