大家都搜：
[自]测试信号
1、signal twice───发出两次信号
2、signal processing───[通信]信号处理
3、alarm signal───[安全]警报信号；n.警报，警报信号
4、digital signal───[自][通信]数字信号
5、signal───adj.显著的；作为信号的；n.(Signal)人名；(瑞典)西格纳尔；vt.标志；用信号通知；表示；n.信号；暗号；导火线；vi.发信号
6、signal words───信号词；标志词
7、home signal───进站信号（机）；[铁路]进站信号；[铁路]进站信号机
8、radio signal───无线电讯号；无线电信号
9、signal wire───[通信]信号线
1、And test signal should be sent no cables, transmission.───及检测信号应可以无缆发送、传输。
2、Compared with traditional methods, difficult test signal design is avoided and isolated signal producing device isn t needed.───与传统测试方法相比，这种方法能避免困难的信号设计过程，不需要DuLi的信号发生设备。
3、The methods based on test signal can be used in management test task. The standard interface of layers is presented for most duplicate.───对测试任务配置时采用基于测试信号的配置方法，各层之间采用标准的接口，以提供最大限度的复用。
4、Cable testing instruments measure crosstalk by applying a test signal to one wire pair.───缆线测试仪器以加上测试讯号到一对线来测量串音。
5、Testing mechanism of the sensor is researched and the relation between test signal and tension is deduced.───研究了索张力传感器的测试机理，导出了传感器测力信号与索张力的关系。
6、In this paper, the emphases are put on the phase shifter test and the idea of the introduction of RF bit test signal to dome.───重点讨论了移相器的BIT设计，以及在不占用XiTong资源条件下将射频BIT测试信号引入罩内的实现方法。
7、With a test signal, this paper introduced three methods on threshold denoising: force threshold, default threshold and given threshold.───结合某测试信号，介绍了阈值消噪的三种方法：强制阈值、默认阈值和给定阈值。
8、Online monitoring of power system test signal contains a lot of background noise, not easy to detect.───电力XiTong在线监测中的检测信号含有大量的背景噪声，不便于检测。
9、The spot testing and analysis by synthesis is adopted to analyze and process the test signal.───采用现场测试与综合分析法，对测试信号进行了分析和处理。
1、Wish you can benefit from our online sentence dictionary and make progress day by day!
2、Test signal through the charge amplifier, A / D data acquisition card into the computer, through professional software can show cutting power.
3、Using the test signal method, a detailed analysis of subsynchronous oscillation for a HVDC system is performed.
4、A new test signal method based approach to design power oscillation damping (POD) controller for TCSC is proposed, by which the bulky eigenvalue calculation of state matrix can be avoided.
5、Online monitoring of power system test signal contains a lot of background noise , not easy to detect.
6、In this paper, a software for analysing the test signal of the dynamic pressure has been developed to evaluate the waveform features, frequency structure and energy distribution.
7、Then the frequency of the test signal is scanned at the HVDC rectifier current set point, and the oscillated active power flow in the parallel AC tie line is obtained.
8、Here, Source-Measure Unit A (SMUA) supplies the test signal to the LED and measures its electrical response while SMUB monitors the photodiode during optical measurements.
9、The methods based on test signal can be used in management test task. The standard interface of layers is presented for most duplicate.