大家都搜：
日光灯；荧光灯管；荧光灯
1、spline tube───花键管
2、fluorescent lights───荧光；荧光灯
3、tube───n.管；电子管；隧道；电视机；vi.乘地铁；不及格；vt.使成管状；把…装管；用管输送
4、fluorescent sand───荧光砂
5、fluorescent───n.荧光；日光灯；adj.荧光的；发亮的
6、fluorescent bulbs───荧光灯；日光灯
7、fluorescent lamp───荧光灯；日光灯；荧光灯管；n.荧光灯（管），日光灯（管）
8、fluorescent light───荧光； 荧光灯；荧光；荧光灯
9、fluorescent paint───荧光漆，荧光涂料；[涂料]荧光涂料
1、This self-charging illuminative module is consisted of a lampshade covered by thin-film solar cells and a fluorescent tube in the middle.───自行充电式照明模组由一个日光灯管及一个灯罩组成，灯罩上布有薄膜太阳能板。
2、using tri-chromatic fluorescent tube, design for reading, give off uniform and natural soft light.───三基色专业读写灯荧光管，读写专用，发光明亮柔和，颜色自然。
3、adopted power save , shadow - less , flash - less ring - formed bright fluorescent tube has no bad effect to vision.───采用节能，无影，无闪烁环型光亮灯管，不会影响视力。
4、Are they expansive comparing to fluorescent tube light? Would like to see some pictures.───他们是膨胀与荧光灯管？想看一些图片。
5、In this paper, a fluorescent tube heat pipe exchanger is designed to complete the performance test.───本文对一台光管热管式换热器进行了台架性能试验。
6、Are they expansive comparing to fluorescent tube light?───他们是膨胀与荧光灯管？
7、In the end, the carbon nanotube field emission fluorescent tube was assembled, lightened and tested in vacuum atmosphere.───最后，组装碳纳米管场发射荧光管，并在真空环境下进行动态点亮测试。
8、microwave radiation generated by the work even more than an ordinary fluorescent tube is even less.───微波辐射的工作，甚至比普通荧光灯管的生成，甚至更少。
1、Table 3 compares the effect of various switching cycles on the life of a typical fluorescent tube.
2、Clips for a fluorescent tube are fitted.
3、The room was about twelve foot square and lit by a fluorescent tube running almost the full length of the ceiling.
4、So a single fluorescent tube will be adequate, and if you have used floating plants, so much the better.
5、Some linoleum tile, maybe some plywood, maybe the buzz of the fluorescent tube light.
6、When the ballast parameter is measured in the fluorescent circuit, the fluorescent tube is in a resistance load of low inductance.
7、It contains a fluorescent tube and can be set at different angles and at varying distances from the working surface.