大家都搜：
输入终端
1、air terminals───n.航空集散站( air terminal的名词复数 )
2、audio input───声频输入（端），音频输入（端）
3、field terminals───磁极线圈出线端
4、indic input───指示器输入
5、passenger terminals───客运枢纽站；旅客航厦
6、inverting input───反相输入；倒相输入
7、mic input───麦克风输入
8、text input───[计]文本输入
9、rated input───额定输入量，额定需求功率；额定处理能力
1、You supply these values by connecting result terminals to input terminals.───您通过将结果终端连接到输入终端来提供这些值。
2、This paper introduced the function of the input terminals and output terminals for remote control. And introduced the some method in use with example.───本文介绍了变频器用于远程控制的输入和输出端子的功能预置，并举例说明几种主要功能的使用方法。
3、Input Voltage Range: The range of voltages on the input terminals for which the amplifier operates within specifications.───输入电压范围，在保证放大器性能的前提下，输入端允许的电压范围。
4、The ideal ammeter should read zero when its input terminals are left open.───当输入端开路时，理想安培计的读数应当为零。
5、The messages from these different sources might arrive at the input terminals at different times and in an unknown order.───来自这些不同源的消息可能在不同的时间到达输入终端，而且不知道该消息的顺序。
6、An overvoltage and overcurrent protection for an exchange terminaL circuit has two input terminals and a number of output terminals.───一种交换机终端电路的过压和过流保护电路，该电路有两个输入端和多个输出端。
7、A short circuit can be connected across the input terminals and the output can then be set to zero, either by front panel zero controls or by computer control.───输入端子之间用一个“短路头”连接，其输出到仪表的输入即为零，也可使用仪器前面板上的消零控制或者用计算机控制来置零。
8、Figure 7 shows a custom mediation containing two input terminals and three output terminals.───图7显示了包含两个输入末端和三个输出末端的自定义中介。
9、Input offset current is the difference between the two input bias currents and this leads to offset errors in in-amps when source resistances in the two input terminals are unequal.───输入失调电流是两个差动输入端的基极输入电流，当两个输入端的源阻抗不相等时，它可引起仪表放大器的失调误差。
1、Normal mode rejection ratio (NMRR) defines how well the instrument rejects or attenuates noise that appears between the HI and LO input terminals.
2、Input Offset Voltage: That voltage which must be applied between the input terminals through two equal resistances to obtain zero output voltage.
3、Input offset current is the difference between the two input bias currents and this leads to offset errors in in-amps when source resistances in the two input terminals are unequal.
4、The power incoming line into control cabinet will be directly connected to the input terminals of the parallel breakers which are located in upside of the control cabinet by users.
5、Normal Mode Rejection Ratio. The ability of an instrument to reject an AC interference (usually of line frequency) across its input terminals. Usually expressed in decibels at a frequency.
6、The ideal ammeter should read zero when its input terminals are left open.