大家都搜：
长度测量
1、carat measurement───克拉测量
2、span length───杆间距离，跨度距离；跨度距离；杆间距离
3、discontinuous measurement───不连续测量
4、length───n.长度，长；时间的长短；音长
5、girth measurement───周长测量
6、measurement chart───尺码表
7、equal length───[统计]等长；[统计] 等长
8、measurement error───[测]测量误差；量度误差
9、measurement───n.测量；[计量]度量；尺寸；量度制
1、Computer simulation is put up to analyze the effect of randomly holding points on cotton length measurement.───计算机模拟的方法，分析了夹持点涨落对测量棉纤维长度的影响。
2、The different time radiography, bone length measurement values different, in that the same should be removed.───不同时间摄片的月状骨长度测量值不同，在进行同一认定时应剔除。
3、System test shows that the designed system can meet the need of high precision length measurement in iron and steel enterprises.───XiTong测试表明，所设计的XiTong可以满足钢铁企业对长度的高精度测量。
4、A flame length measurement method is introduced in this paper.───提出了一种火焰长度的测量方法。
5、The method of pipe length measurement system is elaborated including the constitution, measure principle, as well as measuring process.───论述了测长XiTong的实现方法，介绍了测长XiTong的组成、测长原理、工作过程。
6、It has shown that the length measurement system can meet the demands of the process completely and come up to API international standards.───实践证明，该测长XiTong可完全满足生产工艺过程的要求，达到API国际标准。
7、Finally, the hardware and software of the automatic steel pipe length measurement system employed PLC are designed.───最后介绍了以PLC为控制核心的钢管测长XiTong硬件和软件的构成和实现。
8、On the basis of thin-lens focal length measurement experiment, the imaging law of refraction-reflection system was further studied.───在薄透镜焦距测定实验的基础上，进一步讨论了折射反射XiTong成像的规律。
9、On line length measurement of steel tube is the key point for continuous rolling.───钢管管材长度的在线检测是实现热连轧的基础。
1、Through an experiment for free-form surface measurement, the approach is proven to be simple for parameter computation and its relative error for space length measurement is better than 0.56%.
2、The feasibility of taking strained-wire as navigating datum line of dummy guide-way was analyzed in laser length measurement system, and working principle of the system was presented.
3、You will need to cut all fabric drops to the total length measurement as at the centre of the window.
4、The method and equipment for wave length measurement using the isochromatic spectrum is introduced, and some approaches for improving measurement precision are discussed too.
5、The errors of intraocular lens power calculation may be caused by inaccurate axial length measurement or unstable keratometric reading.
6、Introduces the rationale and techniques of common normal length measurement in the test and mapping of parameters for gears.
7、Bear in mind that all sections must add up to the overall length measurement.