大家都搜：
[机]三点弯曲
1、three to three───三对三
2、bending───n.弯曲，弯曲度；v.弯曲（bend的现在分词）
3、flexural bending───塑性弯曲
4、bending moment───[力]弯矩；[力]弯曲力矩；[力]挠矩；弯（曲）矩，挠矩
5、three point───三点
6、three───num.三；n.三，三个；adj.三的，三个的
7、bending over───俯身；折转
8、flatwise bending───平面弯曲
9、anticlastic bending───抗塑性弯曲
1、Five specimens for three-point static bending tests, five for thickness swelling (ts) were cut from each board according to ASTM D1037-96.───五件样品为三个点的静电弯曲测试，五因为厚度增大(TS)从依照美国材料试验学会D 1037 - 96的每董事会被减低。
2、Structural adhesives - Characterisation of a surface by measuring adhesion by means of the three point bending method.───结构胶粘剂.用三点弯曲法通过测量粘着性测定表面特性
3、This integration scheme is used in an XFEM analysis to model the fracture of a three-point bending beam using the cohesive crack model.───利用基于该积分方案的扩展有限元程序，结合粘聚裂纹模型实现了对三点弯梁开裂过程的模拟。
4、resistance of nitrided J55 casing to sulfide stress cracking (SSC) was studied by C-ring testing and three-point bending testing under different conditions.───应力环腐蚀试验和三(四)点弯曲试验研究了某J 55(即石油套管)渗氮套管在不同试验条件下的腐蚀行为，并和未渗氮套管的抗腐蚀性进行了比较。
5、The bending property of aluminum tubes partially filled with aluminum-foam was studied in the three-point bending experiment.───对泡沫铝合金部分填充方形铝管三点弯曲性能进行研究。
6、Fracture tests for RCC three point bending specimens with different sizes were operated.───进行了不同尺寸碾压混凝土三点弯曲试件的断裂试验。
7、Based on this, this article is trying to use a simple method to get new KR-resistance curve in three-point bending concrete beams. 1.───针对这点，本文尝试用一种简化方法计算混凝土三点弯曲梁的新KR阻力曲线。
8、The influence of mineral admixtures on brittle fracture of mortar was investigated through three-point-bending test.───用三点弯曲法研究了不同种类和掺量的矿物掺和料对砂浆断裂脆性的影响。
1、The three-point bending experiments of the reinforced concrete(RC) beam strengthened with carbon fiber laminate(CFL) were carried out, and the corresponding fatigue life curve was obtained.
2、AE parameters and strength of the electric ceramic materials under three-point bending load are studied.
3、The volume density, open porosities and flexure strength of porous silicon nitride ceramics are measured respectively by Archimedes and three-point bending methods.