大家都搜:
最小直径
1、pitch diameter───层心直径,(齿轮的)节径,(螺纹的)中径;[机]节圆直径
2、shilling diameter───先令直径
3、dime diameter───一角直径
4、minimum order───最低订购量
5、inside diameter───[数]内径
6、minimum───adj.最小的;最低的;n.最小值;最低限度;最小化;最小量
7、outside diameter───外直径;外径
8、diameter───n.直径
9、minimum balance───[经] 最低余额;最低余额;最小库存余量
1、A Heuristic Genetic Algorithm for Minimum Diameter Application Layer Multicast Routing with Degree Constraints───带度约束的最小直径应用层多播路由问题的启发式遗传算法
2、Minimum Diameter Orientations for Tree Vertex-Multiplication Graphs───树的顶点扩张图的最小直径定向
3、Minimum Diameter Orientations of Strong Products of TWO Paths───路与路强乘积的最小直径定向
4、If a minimum diameter is specified the tolerance shall be the total tolerance given in table 8 all over the minimum diameter.───如果指定了最大直径,公差应是表8中给出的总公差,所有的都低于最大直径。
5、In the brush Shape Dynamics Window change the Control from Fade to Pen Pressure, and the Minimum Diameter to 1%.───带度约束的最小直径应用层网络多播路由问题,提出了解决该问题的启发式遗传算法。
6、In the brush Shape Dynamics Window change the Control from Fade to Pen Pressure, and the Minimum Diameter to 1%.───在笔刷形状动态窗口改变“渐隐”到“钢笔压力”,并且最小直径设置成1%。
7、In the brush Shape Dynamics Window adjust the Manage from Fade to Pen Pressure, and the Minimum Diameter to 1%.───在笔刷形状动态窗口改变“渐隐”到“钢笔压力”,并且最小直径设置成1%。
8、Minimum diameter is set to 70%, not too small - not too big.───最小直径设定为70%,不能太小-不是太大。
1、MINIMUM DIAMETER OF THE SUMP IS NPS 12.
2、First, this paper analyzes degree-constraint minimum diameter spanning tree algorithm– the CT algorithm, and proposes the improved CT algorithm.
3、If a minimum diameter is specified the tolerance shall be the total tolerance given in table 8 all over the minimum diameter.