大家都搜:
[流]滑移速度
1、deposit slip───n.存款单
2、angular velocity───[力]角速度
3、velocity───n.【物】速度
4、constant velocity───常速度,等速度; 恒速;匀速;等速度;恒速度
5、cratering velocity───弹坑速度
6、slip───abbr.串行线路接口协议,是旧式的协议 (Serial Line Inte Protocol);adj.滑动的;有活结的;活络的;n.(Slip)人名;(芬)斯利普;n.滑,滑倒;片,纸片;错误;下跌;事故;vt.使滑动;滑过;摆脱;塞入;闪开;vi.滑动;滑倒;犯错;失足;减退
7、bank slip───银行水单,兑换单
8、muzzle velocity───初速;出口速度;初速度(弹出膛时的速度)
9、velocity profile───速度剖面(图),速度分布图,速度变化图
1、While with the increase of the circulating amount of the system, negative pressure gradient and slip velocity in the standpipe increase too.───而随着XiTong循环量的增加,立管内的负压差梯度以及滑移速度均增大;
2、Effect of different road surface, ambient temperature, contact pressure and slip velocity on friction coefficient is apprehended.───初步掌握了路面、温度、垂直压力和滑移速度等因素对摩擦因数的影响。
3、distribution of slip displacement, slip velocity and friction force on the strike slip fault were obtained by numerical simulation.───通过数值计算得到了平移断层上滑移位移、速度及摩擦力的分布规律。
4、The kinetic characters of the material on the slip-stick conveyor are analyzed, and the average slip velocity of the material is obtained.───分析了物料在间歇滑动输送机上运动的特征,得到了物料滑动的平均速度;
5、Maximum slip velocity between the solids and the gas is desirable for good heat transfer and intimate contact.───固体与气体之间的滑流速度应尽可能大,以实现良好的传热和密切接触。
6、According to the simulation data of slip velocity and adhesion coefficient, a fuzzy model, RV-TS model, is built to describe the adhesion characteristic curve.───通过FangZhen实验,采集蠕滑速度和粘着系数的数据,利用RV - TS模型对粘着特性曲线进行模糊建模。
7、negative pressure gradient and slip velocity in standpipe increase with the increase of circulating rate.───随着循环量的增大,立管内的负压差梯度及气固相对速度也随之增大;
8、The existing of boundary slip velocity also influences the full development length of laminar flow in micro scales.───边界上滑移速度的存在,同时也影响层流流动的充分发展长度。
9、The difference between the mean solid velocity and mean gas velocity is called slip velocity.───平均颗粒速度和平均气体速度的差称为滑流速度。
1、The negative pressure gradient and slip velocity in standpipe increase with the increase of circulating rate.
2、According to the simulation data of slip velocity and adhesion coefficient, a fuzzy model, RV-TS model, is built to describe the adhesion characteristic curve.
3、There were significant correlations between the dimensionless apparent slip velocity, apparent solids holdup and slip factor.