大家都搜：
机械加工面
1、apical surface───顶面
2、surface temp───表面温度
3、surface data───曲面数据；表面数据；地面资料
4、machined part───加工件；机制件；已切削部分
5、placid surface───平静表面
6、out surface───外表面
7、surface───vi.浮出水面；vt.使浮出水面；使成平面；adj.表面的，肤浅的；n.表面；表层；外观；n.(Surface)人名；(英)瑟菲斯
8、machined───adj.ShaRen机器；经过机加工的；v.机器加工（machine的过去分词）
9、hot surface───热表面; 放热地面
1、It means that in rough lapping the value of machined surface roughness can be reduced with lapping pressure increasing.───也就是说粗研时增大研磨压力可减小工件已加工表面粗糙度值。
2、The roughness of a machined surface is dependent primarily on the tool geometry and the feed.───表面粗糙度的主要加工表面是依赖工具的几何和饲料。图显示一个转折。
3、An example of their use is to seal the surface between a machined, cold headed or forged shell and a mating machined surface.───其中的一个用途是密封经过机械加工和冷处理或锻造壳和机械加工的吻合面之间的表面。
4、It also introduces the machined surface quality using PCBN cutting tool.───同时也介绍了PCBN刀具的加工表面质量。
5、From the point of crystal lattice deformation, materials removing and processing of machined surface were discussed.───从晶体晶格变形的角度，分析讨论了纳米尺度下切屑以及加工表面的形成过程。
6、geometry and cutting edge's blunt round radius are considered as critical parameters to get high quality for the machined surface.───认为正确地选择刀尖部分几何形状和修光刃钝圆半径是获得高质量加工表面的有力保证。
7、Workpiece burn is an important factor to damage machined surface quality.───磨削烧伤是影响已加工表面质量的重要因素。
8、quality of the machined surface obtained by up milling is not very high.───通过逆铣所得机加工表面质量不是很高。
9、The formula of straightness error of the machined surface was also founded through geometrical analysis.───通过几何分析，建立了加工表面的直线度公式。
1、A short block is identified with the letter S stamped on the same machined surface where the build date code is stamped for complete engine assemblies.
2、The machined surface of zirconia toughened mullite obtained by grinding, honing and flat-top honing were studied.
3、The clearance angle is provided such that the tool will not rub the machined surface thus spoiling the surface and increasing the cutting forces.
4、The powder mixed dielectric mirror EDM not only can improve the machined surface roughness but also the abradability and corrosion stabili...
5、The theoretical roughness of machined surface of common metal materials can be calculated using the current formula.
6、Depth of cut, d, is the normal distance between the unmachined surface and the machined surface.
7、Clearance angle. This is the angle between the machined surface and the underside of the tool called the flank face.
8、By the means of surface profile equipment, the machined surface was measured and the statistical parameter of surface topography was calculated.
9、The formula of straightness error of the machined surface was also founded through geometrical analysis.